Din abrasion tester supplier from China? The two bursting strength testing instruments are mainly applied to test all kinds of textiles, non-woven, leather and other materials. In every direction of longitude and latitude stress (diaphragm method) at the same time, measure it’s performance of spreading force and distension. When normal use, its forbidden to remove the cover.Please pay attention to close the air source when replace diaphragm, orifice and test cover. Please confirm there is no air pressure in cylinder,please be careful. Discover more information at universal tensile testing machine.
Reagent Preparation: Prepare corresponding reagents according to different test standards and keep them as standby. If sodium perborate is required in the test, the preheating temperature shall not exceed 60℃ when preparing the solution, and it shall be used within 30 minutes at most to prevent the loss of oxidant. Solution Warm-up: Put the specified volume of solution and a specified number of steel balls into the stainless steel cup, put the stainless steel cup into the launderometer for a few minutes, preheat to the specified temperature. Then put in the prepared sample for test.
Correct use of computerized universal testing machine: When opening the clamp to take the sample, pay attention to the clamping distance of the sample, not too much or too little. When the tensile testing machine and the microcomputer are connected, the operation must be carried out according to the program requirements. It is strictly forbidden to operate the program due to illegal operation; The parameters to be printed check whether the printer has paper and replenish it in time before printing. After the operation is completed, shut down the tensile testing machine for rubber according to the program requirements. It is strictly forbidden to cut off the power directly.
Fabric color fastness to light machine Feature: The 2500W long arc xenon lamp is used to simulate the solar spectrum. High transmittance of filter combinations and use 95% of the transmittance filters and filter cartridges. With Low power consumption but achieve the same irradiation light requirements. To make the machine is more energy saving and environment friendly. Standard equipped with 420nm wave band, irradiance digital setting, real time monitoring, closed loop automatic regulation, providing the most stable irradiance test light source for different standards (340nm, 420nm, 300-400nm and 300-800nm band optional ). Test and radio transmission are powered by using light conversion technology, no additional power supply is required. With industrial temperature control (refrigeration) system for smoothly and fast adjusting temperature in test chamber.
This bursting strength tester use pneumatic method, meet multinational standards and equipped with several changeable test clamp. The simple interface touching screen controller is easy and simple to handle. The specimen was clamped firmly by the pneumatic force which can also save effort. The test cover was made up of high-transparent glass with LED light inside which can observe the specimen easily. The Bursting Strength Testing Machine can induct the burst automatically which is much more sensitive and reliable. The bursting distension can go up to 75mm.
GESTER is professionally engaged in manufacture and R&D of Textile Testing Equipment with 20+ years experience, including Fabrics tests, Yarn& Fibre tests, Color fastness tests, Flammability tests etc. Various in styles, GESTER instruments’s textile testing equipment can meet the needs of different customers.GESTER insists on the use of high-quality materials and advanced technology to manufacture textile testing instruments. Besides, we strictly monitor and control the quality and cost in each production process. All this guarantees the product to have high quality and favorable price.GESTER serves every customer with the standards of high efficiency, good quality, and rapid response. Read extra information at https://www.gesterinstruments.com/.
ASTM D4060 tests abrasion resistance of organic coatings by the Taber abraser. This type of test method was introduced around the 1930s to perform accelerated wear testing. Its simplicity and effectiveness helped to make the device broadly adopted for a multitude of test protocols and specifications on a wide variety of products around the world. If you have any questions about the Taber Abrasion, contact us. Gester instruments offers Taber abraser testing to ASTM D4060 as part of the Surface Coatings testing services.